Feeler Gauge 0.05 To 1mm 20 Blades 40cm Thickness Gap Metric Gap High Strength Metric Long Thickness Gage For Measurment Tool

<p>Use the feeler:</p><p>1.With a clean cloth to wipe clean the surface measuring feeler measurement, can't have dirty or metal filings in the case of the feeler, otherwise it will affect the accuracy of measurement </p><p>2.The feeler inserted into the measured gap, and pull the feeler, feeling slightly resistance, indicating that the gap values are close to the values marked on the pull feeler; if the resistance is too large or too small, the gap value is less than or greater than the value of the feeler mark </p><p>3.Measure and adjust the gap when the first choice in accordance with provisions of the gap feeler inserted into the measured gap, and then adjust the side, while pulling the feeler, until you feel slightly resistance when tightening the lock nut, the feeler is marked by the numerical value of the measured gap</p>

• Feeler Gauge 0.05 To 1mm 20 Blades 40cm Thickness Gap Metric Gap High Strength Metric Long Thickness Gage For Measurment Tool
• Extended feeler feeler gap ruler feeler monolithic stainless steel400,500,800,1000mm
• Strict quality inspection alloy stainless steel chromium plating surface polishing!
• Main features:
• The wear resistance and pulling resistance, strong toughness, high strength alloy stainless steel surface polishing, chrome plating processing, can protect the surface of each piece of the feeler ruler are printed with specifications, convenient detection and measurement of pure stainless steel seam hardness, low density, tensile strength, wear coefficient is small, in order to improve the strength, toughness and wear resistance tape sheet tension coefficient using stainless steel alloy.
• Matters needing attention:
• (1) are not allowed in the process of measuring severe bending or feeler, with large force hard insert the feeler gauge detected clearance, otherwise it will damage the measuring feeler surface or surface accuracy.
• (2) after use should be clean and feeler, coated with a thin layer of industrial Vase-line, and then back feeler clamp frames, to prevent rust, bending, deformation and damage.
• (3) when stored, can not be put in the feeler under heavy loads, so as to avoid damage to the gauge.